EPOX EP-6VBA Specifications Page 45

  • Download
  • Add to my manuals
  • Print
  • Page
    / 69
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 44
BIOS
EP-6VBA
Page 4-17
4-6 Load Setup Defaults
The “LOAD SETUP DEFAULTS” function loads the system default data directly
from ROM and initializes the associated hardware properly. This function will be
necessary only when the system CMOS data is corrupted.
4-7 Integrated Peripherals
Figure 8: Integrated Peripherals
Note: If you do not use the Onboard IDE connector, then you will need to
set Onboard Primary PCI IDE: Disabled and Onboard Secondary
PCI IDE: Disabled
Note: The Onboard PCI IDE cable should be equal to or less than 18
inches (45 cm.).
IDE Prefetch Mode:
Enable prefetching for IDE drive interfaces that support its faster drive
accesses. If uou are getting disk drive errors, change the setting to omit the
drive interface where the errors occur. Depending on the configuration of your
IDE subsystem, this field may not appear, and it does not appear when the
Internal PCI/IDE field, above, is Disabled.
The Choice: Enabled, Disabled.
ROM PCI/ISA BIOS(2A6LGPAA)
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
OnChip IDE Channel0 : Enabled
OnChip IDE Channel1 : Enabled
IDE Prefetch Mode : Enabled
Primary Master PIO : Auto
Primary Slave PIO : Auto
Secondary Master PIO : Auto
Secondary Slave PIO : Auto
Primary Master UDMA : Auto
Primary Slave UDMA : Auto
Secondary MasterUDMA : Auto
Secondary Slave UDMA : Auto
Init Display First : PCI Slot
Onboard FDD Controller : Enabled
Onboard Serial Port 1 : Auto
Onboard Serial Port 2 : Auto
UART 2 Mode : HPSIR
IR Function Duplex : Half
TX, RX inverting enable : No, Yes
Esc : Quit : Select Item
F1 : Help PU/PD/+/- : Modify
F5 : Old Values (Shift) F2 : Color
F7 : Load Setup Defaults
éé
éé
é
êê
êê
ê
èè
èè
è
çç
çç
ç
Onboard Parallel Port : 378/IRQ7
Onboard Parallel Mode : ECP/EPP
ECP Mode Use DMA : 3
Parallel Port EPP Type : EPP1.9
Onboard Legacy Audio : Enabled
Sound Blaster : Disabled
SB I/O Base Address : 220H
SB IRQ Select : IRQ 5
SB DMA Select : DMA 1
MPU-401 : Disabled
MPU-401 I/O Address : 330-333H
FM Port (388-38BH) : Disabled
Game Port (200-207H) : Enabled
Page view 44
1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 68 69

Comments to this Manuals

No comments