EPOX Pentium 4 Processor based AGP 4X mainboard User Manual download pdf (Page 17)

- 12 -

Step 1

CPU Installation

This mainboard supports Intel Pentium 4/Celeron Socket 478 series CPU.

Please follow the steps as follows to finish CPU installation.

Note the CPU orientation when you plug it into CPU socket.

1. Pull up the CPU socket lever to 90-degree angle.

2. Locate Pin 1 in the socket and look for a black dot or cut edge on the CPU

upper interface. Match Pin 1 and cut edge, and insert the CPU into the

socket.

3. Press down the CPU socket lever and finish CPU installation.

4. Intel Pentium 4/Celeron processors require a set of heatsink and fan to cool

down the processor. You need to purchase a heatsink and fan if they are not

bundled with your CPU. Required is that install the set and plug its cable

in the CPU fan power connector. Note that there are kinds of CPU fan

connectors. Normally, if your mainboard supports a hardware monitoring

function, a 3-pin fan power connector can have your system detect the

CPU fan's speed. A CPU fan with a 2-pin or 4-pin fan power connector

does not support the detection of the CPU fan's speed, and must directly

be connected to the system's power supply unit.

CPU socket lever up to

90-degree angle

CPU Pin 1 and cut edge

Note:The CPU might be

damaged if you do not match

the CPU socket Pin 1 and cut

edge well.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 80 81

No comments

EPOX Pentium 4 Processor based AGP 4X mainboard User Manual Page 17